CS and IT GATE 2018 Questions with Answer

Ques 14 C Programming

Consider the following C program.

Ques 15 COA

A processor has 16 integer registers (R0, R1, … , R15) and 64 floating point registers (F0, F1, … , F63). It uses a 2-byte instruction format. There are four categories of instructions: Type-1, Type-2, Type-3, and Type 4. Type-1 category consists of four instructions, each with 3 integer register operands (3Rs). Type-2 category consists of eight instructions, each with 2 floating point register operands (2Fs). Type-3 category consists of fourteen instructions, each with one integer register operand and one floating point register operand (1R+1F). Type-4 category consists of N instructions, each with a floating point register operand (1F). The maximum value of N is _______

Ques 16 COA

A 32 - bit wide main memory unit with a capacity of 1 GB is built using 256M X 4-bit DRAM chips. The number of rows of memory cells in the DRAM chip is 214. The time taken to perform one refresh operation is 50 nanoseconds. The refresh period is 2 milliseconds. The percentage (rounded to the closest integer) of the time available for performing the memory read/write operations in the main memory unit is _______ .

Ques 17 COA

Consider the following processor design characteristics.

I. Register-to-register arithmetic operations only
II. Fixed-length instruction format
III. Hardwired control unit

Which of the characteristics above are used in the design of a RISC processor?

Ques 18 Computer Network

Consider a long-lived TCP session with an end-to-end bandwidth of 1 Gbps (= 10⁹ bits-per-second). The session starts with a sequence number of 1234. The minimum time (in seconds, rounded to the closest integer) before this sequence number can be used again is _______

Ques 19 Computer Network

Consider a simple communication system where multiple nodes are connected by a shared broadcast medium (like Ethernet or wireless). The nodes in the system use the following carrier-sense the medium access protocol. A node that receives a packet to transmit will carrier-sense the medium for 5 units of time. If the node does not detect any other transmission in this duration, it starts transmitting its packet in the next time unit. If the node detects another transmission, it waits until this other transmission finishes, and then begins to carrier-sense for 5 time units again. Once they start to transmit, nodes do not perform any collision detection and continue transmission even if a collision occurs. All transmissions last for 20 units of time. Assume that the transmission signal travels at the speed of 10 meters per unit time in the medium. Assume that the system has two nodes P and Q, located at a distance d meters from each other. P starts transmitting a packet at time t = 0 after successfully completing its carrier-sense phase. Node Q has a packet to transmit at time t = 0 and begins to carrier-sense the medium. The maximum distance d (in meters, rounded to the closest integer) that allows Q to successfully avoid a collision between its proposed transmission and P’s on going transmission is _______

Ques 20 Computer Network

Consider an IP packet with a length of 4,500 bytes that includes a 20-byte IPv4 header ans 40-byte TCP header. The packet is forwarded to an IPv4 router that supports a Maximum Transmission Unit (MTU) of 600 bytes. Assume that the length of the IP header in all the outgoing fragments of this packet is 20 bytes. Assume that the fragmentation offset value stored in the first fragment is 0. The fragmentation offset value stored in the third fragment is ______ .

Ques 21 Digital Logic Design

Consider the minterm list form of a Boolean function F given below.

Ques 22 Discrete Mathematics

Let G be a finite group on 84 elements. The size of a largest possible proper subgroup of G is _______ .

Ques 23 Discrete Mathematics

Which one the following is a closed form expression for the generating function of the sequence {a_n}, where a_n = 2n + 3 for all n = 0, 1, 2,...?

Ques 24 Operating System

Consider a storage disk with 4 platters (numbered as 0, 1, 2 and 3), 200 cylinders (numbered as 0, 1, … , 199), and 256 sectors per track (numbered as 0, 1, … 255). The following 6 disk requests of the form [sector number, cylinder number, platter number] are received by the disk controller at the same time: [120, 72, 2], [180, 134, 1], [60, 20, 0], [212, 86, 3], [56, 116, 2], [118, 16, 1] Currently head is positioned at sector number 100 of cylinder 80, and is moving towards higher cylinder numbers. The average power dissipation in moving the head over 100 cylinders is 20 milliwatts and for reversing the direction of the head movement once is 15 milliwatts. Power dissipation associated with rotational latency and switching of head between different platters is negligible. The total power consumption in milliwatts to satisfy all of the above disk requests using the Shortest Seek Time First disk scheduling algorithm is ______

Ques 25 Operating System

The size of the physical address space of a processor is 2^P bytes. The word length is 2^W bytes. The capacity of cache memory is 2^N bytes. The size of each cache block is 2^M words. For a K-way set-associative cache memory, the length (in number of bits) of the tag field is

Ques 26 Operating System

Consider a process executing on an operating system that uses demand paging. The average time for a memory access in the system is M units if the corresponding memory page is available in memory, and D units if the memory access causes a page fault. It has been experimental measured that the average time taken for a memory access in the process is X units. Which one of the following is the correct expression for the page fault rate experienced by the process?