Civil Engineering > GATE 2014 SET-1 > Structural Analysis
Match the information given in Group - I with those in Group - II.
| Group-I | Group-II |
|---|---|
| P. Factor to decrease ultimate strength to design strength | 1. Upper bound on ultimate load |
| Q. Factor to increase working load to ultimate load for design | 2. Lower bound on ultimate load |
| R. Statical method of ultimate load analysis | 3. Material partial safety factor |
| S. Kinematical mechanism method of ultimate load analysis | 4. Load factor |
Correct : c
Similar Questions
For the cantilever beam of span 3 m (shown below), a concentrated load of 20 kN applied at the free end causes a vertical displacement of 2 mm at a section loca...
For the cantilever beam of span 3 m (shown below), a concentrated load of 20 kN applied at the free end causes a vertical displacement of 2 mm at a section loca...
For the truss shown below, the member PQ is short by 3 mm. The magnitude of vertical displacement of joint R (in mm) is _______.
Total Unique Visitors
Loading......